Question about EuroCave Refrigerators

2 Answers

Eurocave Gamme Compact ' PTC Starter or Overload Protector Replacement Part?

I have a Eurocave Gamme Compact (Viellitheque 156W), 115 Volts wine refrigerator. Trying to find where I can purchase a PTC Starter (or Start Relay). I've found the replacement part but doesn't appear they ship to the U.S. Thanks in advance for your response! aspera 226020904 siemens 00417964 https://kremplshop.de/p/anlaufvorrichtung-aspera-emy20-clc-00417964-6290438411

Posted by Anonymous on

2 Answers

john h

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Vr2020 Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • EuroCave Master
  • 23,401 Answers

Check with local appliance repair shops for a compatible one

Posted on Mar 29, 2020

Jorgie Navito

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • EuroCave Master
  • 357 Answers

TRY EBAY

Posted on Mar 29, 2020

5 Related Answers

aborcass

Ron Coons

  • 2651 Answers

SOURCE: compressor clicking on and off fridge now warm

looked up your model number and got a part number of 8201799. is that the number you got??? cause in the pic it looks like there are 3 terminals on the relay(brown piece) there should have also been instructions in the package no???

Posted on Mar 29, 2008

Anonymous

  • 1 Answer

SOURCE: freezer stopeed working

Thanks for the answer and the question.
I have changed the defroster clock and the repair shop who sold it told me that is 6 1/2 hours between defrost. the case is that this time is not the correct as it looks because between turning on the DEFROST cycle and then start up again the time in between is not sufficient that the freezer makes the right defrost. and the temperature stays around 32 F.
now if I make a bridge between socket no 1 and 2 the resistor will start and in 20 minutes the water will show up under the freezer and then I connect the timer again and the tep. will go down to 20 F.

I really have no Idea what is wrong any help. I am grateful and happy.

Posted on Sep 22, 2008

Anonymous

  • 1 Answer

SOURCE: Kenmore refrigerator PTC relay for compressor

This is for a Kenmore PTC relay that I just pulled from my fridge. It dosn't have an ice maker. Hope this helps.

Pin 1 = White
Pin 4 = Blue
Gold Pin = Red

Posted on Nov 05, 2008

c17hydro

Greg Bernett

  • 2989 Answers

SOURCE: Where can I find a replace thermal overload protector?

http://www.mypool.com/Products/Catalog/mo.asp for the capacitor.

See if there is another part number for that breaker (CET51 ABM).

Posted on Mar 10, 2009

SOURCE: need replacement thermal overload protector

Check the Radio Shack website. Match the temperature rating of the thermal fuse.

These can't be soldered in -- the heat will blow them -- they are best crimped in.

Posted on Apr 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replacement power cord for Eurocave wine art


Vr2020 does not sell replacement power cords.

Oct 10, 2016 | EuroCave Refrigerators

1 Answer

Not cooling and compressor is hot


If the overload was open circuit you would not have a hot compressor. The overload activates because the compressor won't start. If there is a capacitor starter, change it. If not let it cool for at least a day then try again. If still no go, replace compressor.

Apr 09, 2014 | Magic Chef MCWC30MCG Compact Wine Cooler

1 Answer

My fidge is a kenmore medel 25357685790 my starter ptc looks to be burnt so i decided to replace it but it includes three pieces the capacitor, starter ptc and overload. the new parts only have a diffrent...


HI,
I use ERP 410 (relay capacitor and overload) Get it at your local Appliance Parts Store
Very easy to install
Leo Ponder
imufo2
Please vote for me if this helps.

Aug 02, 2011 | Refrigerators

1 Answer

Magic Chef Model #MCBR360S just quit working all of a sudden. Any suggestions for solving this problem would be appreciated.


Check the PTC starter component. It is a small ceramic disc inside a plastic housing, attached to the side of the motor. If it is an open state, the motor will not start, If it is shorted, the motor will start, but the overload will trip in just a few seconds. The resistance across the PTC should be around 7 ohms at room temperature. I recently had the same symptoms on my MCBR440. The PTC had some arcing on it. A simple cleaning of the surfaces by scraping with a sharp knife and then reassembling it did the trick.

The resistance across the thermostat in it's running position should be zero. The resistance across the motor overload protector should be zero. The resistance across the motor windings (start, and run) should be just a few ohms. MAKE SURE YOU DISCONNECT THE POWER cable before attempting to measure the resistance of any of the electrical components. All of the wiring is easily accessible from the rear.

Lightfoot_55

Dec 15, 2010 | Magic Chef MCBR440 Compact Refrigerator

1 Answer

When plugged in, the compressor doesn't activate. When you press the test button, the compressor turns on. After doing that about fivetimes, the compressor won't even flip on? This is a Eurocave Model...


if you keep starting it it will quit any way . but this sounds like a start relay or a bad or run cap / but you could have a bad compressor also . and if running on a long ext cord it cause this problem so ck these / hope this has helped mm feed back pls ..

Nov 25, 2010 | EuroCave S256T Wine Cooler

1 Answer

Eurocave comfort 264: Problem, ice formation inside the unite , half the way the middle section of the unit ( Racks 8-10)


It's likely that you need to change the filter. Have a look at this post: http://blog.wineenthusiast.com/2009/04/20/caring-for-your-eurocave-3-simple-steps-towards-long-lasting-wine-protection/

Sep 30, 2010 | EuroCave Comfort 260 Collector's Package...

2 Answers

Light comes on when you open door but wine cooler does not come one (does not cool). Checked all circuit breakers.


check thermostat set it to the coldest setting if doesnt come on test stat for power if power jump stat see if starts if still doesnt test for power at compressor if power than check thermo safety for compressor if good than compressor has an internal problem which will probably require a replacement

May 15, 2010 | KitchenAid Architect KUWA244PSS Stainless...

1 Answer

Eurocave Repair


can you tell if if it's running by putting your hand on the compressor,then we can go from there

Dec 17, 2008 | EuroCave Comfort 260 Collector's Package...

6 Answers

Magic Chef MCWC30MCG not getting cold?


You need to replace the Ptc unit attached to the compressor. Go to REPAIR CLINIC.COM and order the following part. 1206838 Ptc relay. They also will show you were it is located and how to replace it. Compressor tanks very rarely go bad. It is an $11.00 dollar part

May 28, 2008 | Magic Chef MCWC30MCG Compact Wine Cooler

1 Answer

Magic Chef MCWC30MCG not getting cold anymore?


Replace PTC Starter and that is it. You can also try to open and clean contacts, I did and it worked.

May 28, 2008 | Magic Chef MCWC30MCG Compact Wine Cooler

Not finding what you are looking for?
Refrigerators Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top EuroCave Refrigerators Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

john h

Level 3 Expert

23401 Answers

Jorgie Navito
Jorgie Navito

Level 3 Expert

357 Answers

Are you an EuroCave Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...